FAQ (DC688)

FAQ List
1. Backlight power supply
- Note that when the screen is larger than 27 inches, the backlight current will exceed 3A, exceeding the power supply capability of the mainboard. It is recommended to supply 12V power to the backlight separately
2. How do I enable/disable auto power-on for DC688?
You need to add or remove the 0Ω resistor R170 on the back. During the debugging stage only, it can be replaced directly with solder or copper wire
R170 Resistor Status Resistance Present Auto power-on when powered 0Ω Absent No auto power-on None
Location of R170
3. Mainboard mounting direction and gravity sensing settings
The
DC688mainboard has passed Google EDLA certification, which imposes mandatory requirements on firmware and does not allow personalized customization.We have developed a USB drive production solution so that customers can implement light functional customization. Therefore, the display orientation can be written in batches via a USB drive; the written orientation is stored separately and will not be affected by a factory reset.
Direct setting:
The gravity sensor acceleration direction can be set directly under System - Developer options - Acceleration settings, and is not affected by a factory reset
After you have the configuration, you can use DC688 USB Drive Production to configure each machine in batches.
-
Direction description:
-
Front: the mainboard is fixed to the rear shell, and components such as the SoC face the same direction as the screen display surface.
-
Back: the mainboard is fixed behind the screen, mounted directly on the back of the screen.
-
0 degrees: usually the
DC688is mounted with its IO interfaces facing down, i.e.0 degrees. -
The mounting direction is not fixed for different products and form factors; adjust the setting according to the specific situation.
-
4. How do I quickly enable ADB
-
Create a file named
FANCONN_ADB.txtin the root directory of aFAT32USB drive. Thecontent does not matter,the file only needs to exist. Insert it into the device while powered on and ADB is enabled automatically. -
Insert the USB drive after ADB is enabled. If the data cable is inserted first, the USB drive will not be recognized. Please refer to: -
You can also check the device IP and connect via
adb connect ip -
If it does not work, check whether the system recognizes the
USB driveproperly
tips: To be recognized, make sure the
USB driveis inFAT32format, andFANCONN_ADB.txtdoes not need any contenttips: If the
USB driveis not recognized, insert it into the device, go toSettings-Storage- upper-leftselect your USB drive--> theUSB drive, and follow the prompts toformat it step by step; remember to back up your data
5. Type C debugging issues
-
Note that the
Type-Cport is designed only forsystem upgradeanddevice debugging -
When the
TYPE-Cport is connected to a computer for debugging:the USB-A ports cannot be used
During ADB debugging: USB devices such as mice and USB drives cannot be connected
6. Google Play APP testing
For DC688 app testing, see

