Skip to main content

Quick Install - Windows

Navigation bar

BG96 Installation​

Quickly get started with the BG96 LTE Cat M1 / NB-IoT Dongle on Windows

Prerequisites​

  1. A Windows PC
  2. Dongle BG96 and a USB data cable
  3. A Nano-SIM card with LTE Cat M1 or NB-IoT activated
  4. Windows USB driver

Installing the Nano-SIM Card​

Note

The Nano-SIM card is shown for demonstration only and is not included with this product. If a regular 4G SIM has no Cat M1 / NB-IoT service activated, the module cannot register on the network.

Image

  1. If the device has a USB protective cover, remove it first (skip this step for bare-board devices without an enclosure)
  2. Push the Nano-SIM card into the slot in the direction indicated on the slot, and make sure it is seated firmly

Connecting to the PC USB Port​

Simply plug the USB-A connector into a USB port on the PC; if the USB port cannot supply enough power, a powered USB hub is recommended.


Configuring the Dongle​

Downloading the Driver​

Quectel_LTE&5G_Windows_USB_Driver_V2.2.4 (for BG95-M3 and regular EC20 dongle).zip

The USB composition of the BG96 is fixed and cannot be switched to ECM/RNDIS with AT+QCFG="usbnet"; if the module has already been switched (for example, using a Quectel tool), install the corresponding NDIS / MBIM driver.

Checking the Device​

  1. Insert the SIM card and connect the dongle to the PC
  2. Open This PC → Manage(G) → Device Manager → Other devices
  3. You should see BG96 with no driver installed

Installing the Driver​

  1. Download and extract the driver
  2. Run the installer and click Next
  3. After installation, the Quectel network adapter appears under Device Manager → Network adapters

After the driver is installed, several Quectel AT ports appear under Ports (COM & LPT), which can be used for Device Debugging.

Getting Online​

Once the driver is installed, Windows automatically obtains an IP address through the module. Open a browser and browse the web.

Tip

The BG96 supports only Cat M1 / NB-IoT. If the SIM does not have the corresponding service activated, the driver installs correctly but the device cannot connect to the Internet. Use the AT port to run AT+CPIN?, AT+CSQ and AT+CEREG? to check the status.

Driver Not Recognized​

If some devices are still not recognized, refer to:

Solution for AT port not working after switching to ECM or RNDIS.docx

For Linux / OpenWrt, refer to Quick Install - Linux / OpenWrt.

AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →