Skip to main content

Upgrade Introduction

Navigation Bar

Preface​

This document describes how to flash firmware from a host PC to Rockchip series development boards. During the upgrade, you need to choose the appropriate upgrade method based on the host operating system and the firmware type.

If you want to run another operating system, you need to flash the corresponding firmware to the mainboard.

In general, Rockchip development boards will not be bricked unless the hardware is damaged.

Required Tools​

  • Rockchip mainboard/device
  • PC host
  • A properly working data cable

Prepare the Firmware​

The firmware can be obtained by compiling the SDK, or downloaded from the Firmware Download section. Firmware files generally come in two forms:

Single firmware and partitioned firmware. With the unified firmware unpacking/packing tool, you can unpack unified firmware into multiple partition images, or merge multiple partition images into a single unified firmware.

  • Single firmware contains multiple partition images and is a single file packed and merged from the partition table, bootloader, uboot, kernel, system, and all other files.

    Officially released firmware uses the single firmware format. Upgrading a single firmware will update the data and partition table of all partitions on the mainboard and erase all data on the mainboard.

  • Partitioned firmware refers to individual files for each function, such as the partition table, bootloader, and kernel, generated during the development stage.

    Separate partition images allow you to update only the specified partitions while keeping the data in other partitions intact, which makes debugging much easier during development.

Flashing Tool​

Driver​

  • To ensure that all devices use the updated driver, please select driver uninstall first, and then select driver installation.

Release_DriverAssistant.zip

Photo Install the driver

Flashing Tool​

RKDevTool_Release_v3.32

Photo Extract and run RKDevTool.exe in the RKDevTool_Release_v3.32 directory (note: on Windows 7/8, right-click and select Run as administrator)

Upgrade Methods​

Rockchip supports upgrading firmware in the following ways:

Upgrading Firmware via EMMC/UFS​

  • Use Rockchip to connect the mainboard to the computer, and flash the firmware to the mainboard EMMC with the upgrade tool.

Boot Modes​

Normal Mode​

Normal mode is the regular boot process, in which each component is loaded in sequence and the system starts normally.

Loader Mode​

In Loader mode, the bootloader enters the upgrade state, waiting for host commands, and is used for firmware upgrades, etc.

MaskRom Mode​

MaskRom mode is used for system repair when the bootloader software is damaged.

If Loader cannot be detected, you can try MaskRom to repair Loader
AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →