Skip to main content

Upgrade Firmware

Navigation Bar

Preface​

This document describes how to flash firmware from a host PC to the storage of a Rockchip development board via a data cable.

During the upgrade, you need to select the firmware according to your actual requirements and choose the appropriate upgrade method.

Obtaining the Firmware​

Link: https://pan.baidu.com/s/1nx1dpgBArjLqYNcTYox3xA?pwd=fanc Extraction code: fanc

DC690H Conference Device Public Firmware​

Rockchip-DC690H-A14-HYJ-Fanconn

Link: https://pan.baidu.com/s/19iUqzg1feEItcDd2QNIXiA?pwd=fanc Extraction code: fanc

DC690H Conference Device Public Overseas Firmware​

Rockchip-DC690H-A14-HYJ-GMS

Link: https://pan.baidu.com/s/1E93cvH7o4Yvj0lul48QASQ?pwd=fanc Extraction code: fanc

Installing the Flashing Tool​

Download the Files​

Install the RK USB driver Release_DriverAssistant.zip

Run the RK flashing tool RKDevTool_Release_v3.32

Extract​

  • Extract Release_DriverAssistant and RKDevTool_Release_v3.32

Photo Extract the tools

Install the Driver​

  • To ensure that all devices use the updated driver, please select driver uninstall first, and then select driver installation.

Photo Install the driver

Run the Flashing Tool​

Photo Extract and run RKDevTool.exe in the RKDevTool_Release_v3.32 directory (note: on Windows 7/8, right-click and select Run as administrator)

Entering Loader Mode​

There are two ways to enter Loader mode:

Entering Loader Mode via Terminal Commands​

Enter the command directly in the terminal:

  • After the adb terminal starts, you can enter reboot loader to enter it.

Photo Entering Loader mode

Entering MaskRom Mode via the BOOT Button​

Switch to upgrade mode with the boot button:

  1. Disconnect all power
  2. Press the boot button
  3. Connect the USB data cable, then connect power; the device powers on automatically and enters MaskRom mode
  4. You can then release the BOOT button.

photo Press and hold the Boot button, then power on

Starting the Upgrade​

Follow the steps below to upgrade Rockchip

Upgrade Steps​

  • 1-2 Extract the firmware
  • 3 Verify that Loader mode is entered
  • 4 For the firmware, select the img firmware extracted in the previous step Obtaining the Firmware
  • 5 Click the upgrade button

Note that each firmware has a different name; the file name is for reference only

Photo Start the upgrade

Completing the Upgrade​

Wait until Firmware downloading 100% and Firmware downloaded successfully are displayed, which means the upgrade is complete.

Photo Upgrade completed

AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →