Skip to main content

FAQ (DC685-F)

Navigation Bar


FAQ List​

1. Backlight power supply​

  • Note that when the screen is larger than 27 inches, the backlight current will exceed 3A, exceeding the power supply capability of the mainboard. It is recommended to supply 12V power to the backlight separately

Common questions about the DC685:

2. Mainboard mounting direction and gravity sensing settings​

The DC685/DC685-F series mainboards have passed Google EDLA certification, which imposes mandatory requirements on firmware and does not allow personalized customization.

We have developed a USB drive production solution so that customers can implement light functional customization. Therefore, the display orientation can be written in batches via a USB drive; the written orientation is stored separately and will not be affected by a factory reset.

Direct setting:

The gravity sensor acceleration direction can be set directly under System - Developer options - Acceleration settings, and is not affected by a factory reset

After you have the configuration, you can use DC685 USB Drive Production to configure each machine in batches.

After you have the configuration, you can use DC685F USB Drive Production to configure each machine in batches.

  • Direction description:

    • Front: the mainboard is fixed to the rear shell, and components such as the SoC face the same direction as the screen display surface.

    • Back: the mainboard is fixed behind the screen, mounted directly on the back of the screen.

    • 0 degrees: usually the DC685 is mounted with its IO interfaces facing down, or the 685F expansion board cable facing down, i.e. 0 degrees.

    • The mounting direction is not fixed for different products and form factors; adjust the setting according to the specific situation.


3. How do I quickly enable ADB​

  • Create a file named FANCONN_ADB.txt in the root directory of a FAT32 USB drive. The content does not matter, the file only needs to exist. Insert it into the device while powered on and ADB is enabled automatically.

  • Insert the USB drive after ADB is enabled. If the data cable is inserted first, the USB drive will not be recognized. Please refer to:

  • You can also check the device IP and connect via adb connect ip

  • If it does not work, check whether the system recognizes the USB drive properly

tips: To be recognized, make sure the USB drive is in FAT32 format, and FANCONN_ADB.txt does not need any content

tips: If the USB drive is not recognized, insert it into the device, go to Settings - Storage - upper-left select your USB drive --> the USB drive, and follow the prompts to format it step by step; remember to back up your data

USB Drive Formatting Reference


4. Type C debugging issues​

  • Note that the Type-C port is designed only for system upgrade and device debugging

  • When the TYPE-C port is connected to a computer for debugging: the USB-A ports cannot be used

During ADB debugging: USB devices such as mice and USB drives cannot be connected


Image


AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →