Skip to main content

Upgrade Guide

Navigation bar

Introduction​

This document describes how to flash firmware onto Rockchip series development boards. The appropriate upgrade method depends on your host operating system and the firmware type.

To run a different operating system, you need to flash the corresponding firmware onto the mainboard.

Under normal circumstances, unless there is hardware damage, Rockchip development boards are very difficult to brick.

If an unexpected issue occurs during the upgrade process, such as bootloader corruption preventing re-upgrade, you can still enter MaskRom mode to repair it.

Preparation​

  • Rockchip mainboard / device
  • PC Host
  • A functional USB data cable

Firmware Preparation​

Firmware can be obtained by compiling from the SDK or by downloading pre-built firmware from the Downloads / Resources section. Firmware files generally come in two types:

Single firmware and partitioned firmware. Using unified firmware packaging/unpacking tools, you can unpack a single firmware file into multiple partition images, or combine multiple partition images into a single unified firmware file.

  • Single Firmware: Contains multiple partition images. It is a single file打包合并 created by packaging the partition table, bootloader, uboot, kernel, system, and all other files together.

    Officially released firmware uses the single firmware format. Upgrading with a single firmware file will update the data and partition table of all partitions on the mainboard and erase all data on the board.

  • Partitioned Firmware: Consists of functionally independent files generated during the development stage, such as the partition table, bootloader, and kernel.

    Individual partition images allow updating only the specified partition without affecting data in other partitions, which is very convenient for debugging during development.

Flashing Tools​

Driver​

  • To ensure all devices use updated drivers, please select Uninstall Driver first, then select Install Driver.

Release_DriverAssistant.zip

Photo Installing Driver

Flashing Tool​

RKDevTool_Release_v3.32

Photo Unzip the file, then run RKDevTool.exe located in the RKDevTool_Release_v3.32 directory. (Note: For Windows 7/8, right-click and select Run as administrator).

Upgrade Methods​

Rockchip supports upgrading firmware via the following methods:

Upgrading via EMMC/UFS​

  • Connect the mainboard to your computer via USB and use the Rockchip flashing tool to burn the firmware onto the board's EMMC.

LKB1126BP supports upgrading firmware via the following two methods:

Upgrading via EMMC

Connect the LKB1126BP mainboard to the computer and use the flashing tool to burn the firmware onto the board's EMMC. Using a MicroSD Card

Use an upgrade card creation tool to prepare a MicroSD card as an upgrade card. Insert the card into the mainboard, power on the device, and the machine will automatically execute the upgrade.

Boot Modes​

Normal Mode​

Normal mode is the standard boot process where components load sequentially, leading to a normal system startup.

Loader Mode​

In Loader mode, the bootloader enters an upgrade state, waiting for commands from the host PC. This mode is used for firmware upgrades, etc.

MaskRom Mode​

MaskRom mode is used for system recovery when the bootloader software is corrupted.

If the device is not detected in Loader mode, you can try using MaskRom mode to repair the Loader.
AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →