Upgrade Introduction

Preface
This document describes how to flash the firmware from a host PC to the CAM126 development board. When upgrading, you need to choose the appropriate upgrade method according to the host operating system and firmware type.
If you want to run another operating system, you need to flash the corresponding firmware to the board.
Under normal circumstances, the CAM126 development board will not be bricked unless the hardware is damaged.
Tools to Prepare
- CAM126 board/device
- PC host
- A properly working data cable
Preparing the Firmware
The firmware can be obtained by building the SDK, or downloaded from the firmware download page. There are generally two kinds of firmware files:
Single firmware and partition firmware. With the unified firmware unpacking/packing tool, a unified firmware can be unpacked into multiple partition images, and multiple partition images can also be merged into a single unified firmware.
-
Single firmware contains multiple partition images and is a single file packed and merged from the partition table, bootloader, uboot, kernel, system, and all other files.
All officially released firmware uses the single firmware format. Upgrading a single firmware will update the data of all partitions and the partition table on the board, and erase all data on the board.
-
Partition firmware refers to the individual files for each function, such as the partition table, bootloader, kernel, etc., generated during the development phase.
An independent partition image can update only the specified partition while keeping the data of other partitions intact, which is very convenient for debugging during development.
Flashing Tools
Driver
- So that all devices use the updated driver, please select
driver uninstall first, and then select driver install.
Install the driver
Flashing Tool
Extract the archive and run RKDevTool.exe in the RKDevTool_Release_v3.32 directory (note: on Windows 7/8, right-click it and choose Run as administrator)
Upgrade Methods
CAM126 supports upgrading the firmware in the following ways:
Upgrading the Firmware via EMMC
- Connect the board to the computer using CAM126, and flash the firmware to the board's EMMC with the upgrade tool.
Boot Modes
Normal Mode
Normal mode is the regular boot process, in which each component is loaded in sequence and the system starts normally.
Loader Mode
In Loader mode, the bootloader enters the upgrade state and waits for commands from the host, and is used for firmware upgrades, etc.
Install the driver