Skip to main content

Upgrade Introduction

Navigation bar

Introduction​

This document describes how to flash firmware from a host PC to Rockchip series development boards. During an upgrade, you need to choose an appropriate upgrade method based on the host operating system and the firmware type.

If you want to run another operating system, you need to flash the corresponding firmware to the mainboard.

Under normal circumstances, a Rockchip development board will not be bricked unless the hardware is damaged.

Tools Required​

  • Rockchip mainboard/device
  • PC host
  • A well-functioning data cable

Preparing Firmware​

The firmware can be obtained by building the SDK, or downloaded from the Firmware Download section. There are generally two types of firmware files:

Single firmware and partition firmware. Using the unified firmware unpack/pack tool, you can unpack unified firmware into multiple partition images, or merge multiple partition images into a single unified firmware.

  • Single firmware contains multiple partition images and is a single file packaged and merged from all files such as the partition table, bootloader, uboot, kernel, and system.

    Officially released firmware is always in the single firmware format. Upgrading the single firmware will update the data and partition table of all partitions on the mainboard and erase all data on the mainboard.

  • Partition firmware refers to individual files for each function, such as the partition table, bootloader, and kernel, generated during the development phase.

    Standalone partition images allow you to update only a specified partition while keeping the data of other partitions intact, which is very convenient for debugging during development.

Flashing Tools​

Driver​

  • To make all devices use the updated driver, please first select Driver Uninstall, and then select driver installation.

Release_DriverAssistant.zip

Photo Install the driver

Flashing Tool​

RKDevTool_Release_v3.32

Photo Extract and run RKDevTool.exe from the RKDevTool_Release_v3.32 directory (note: on Windows 7/8, right-click and select "Run as administrator")

Upgrade Methods​

Rockchip supports upgrading firmware in the following ways:

Upgrading Firmware via EMMC​

  • Connect the mainboard to the computer using a Rockchip device, and flash the firmware to the mainboard EMMC with the upgrade tool.

Boot Modes​

Normal Mode​

Normal mode is the regular boot process, in which each component is loaded in sequence and the system starts normally.

Loader Mode​

In Loader mode, the bootloader enters the upgrade state and waits for host commands, which is used for firmware upgrades and so on.

AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →