Upgrade Overview

Introduction
This document describes how to flash firmware from a host PC to a Rockchip development board. During the upgrade, choose the appropriate method based on the host operating system and the firmware type.
To run another operating system, flash the corresponding firmware to the board.
Under normal circumstances, a Rockchip development board will not be bricked unless the hardware is damaged.
Prepare Tools
- Rockchip board/device
- PC host
- A working data cable
Prepare Firmware
Firmware can be built from the SDK or downloaded from the Firmware Download section. Firmware files generally come in two forms:
Single-file firmware and partition firmware. Using the unified firmware unpack/pack tool, a unified firmware can be unpacked into multiple partition images, or multiple partition images can be merged into a single unified firmware.
-
Single-file firmware contains multiple partition images and is a single file packed from the partition table, bootloader, uboot, kernel, system and all other files.
Officially released firmware uses the single-file format. Upgrading a single-file firmware updates the data and partition table of all partitions on the board and erases all data on the board.
-
Partition firmware consists of independent functional files such as the partition table, bootloader and kernel, and is generated during the development stage.
Individual partition images can update only the specified partition while keeping the data of other partitions intact, which is very convenient for debugging during development.
Flashing Tools
Driver
- To ensure all devices use the latest driver, first select
Driver Uninstall , and then select driver installation.
Install the driver
Flashing Tool
Extract the archive and run RKDevTool.exe inside the RKDevTool_Release_v3.32 directory (note: on Windows 7/8, right-click and choose "Run as administrator")
Upgrade Methods
Rockchip supports upgrading firmware in the following ways:
Upgrade Firmware via EMMC
- Connect the board to the computer with the Rockchip tool, and flash the firmware to the board's EMMC using the upgrade tool.
Boot Modes
Normal Mode
Normal mode is the regular boot process, in which each component is loaded in sequence and the system starts normally.
Loader Mode
In Loader mode, the bootloader enters the upgrade state and waits for host commands, which is used for firmware upgrades and similar operations.
Install the driver
Extract the archive and run RKDevTool.exe inside the RKDevTool_Release_v3.32 directory (note: on Windows 7/8, right-click and choose "Run as administrator")