Firmware Upgrade

Preface
This document describes how to flash firmware from a host PC into the storage of the DL568 module via a data cable.
Choose the firmware and the appropriate upgrade method according to your actual needs.
Obtaining Firmware
Build from the SDK
The DL568 SDK has not been publicly released yet.
Installing the Flashing Tool
Download Resources
Install the RK USB driver: Release_DriverAssistant.zip
Run the RK flashing tool: RKDevTool_Release_v3.32
Extract
- Extract
Release_DriverAssistant andRKDevTool_Release_v3.32
Extract the tools
Install the Driver
- To ensure all devices use the latest driver, select
Uninstall Driver first, then select Install Driver.
Install the driver
Run the Flashing Tool
Extract and run RKDevTool.exe in the RKDevTool_Release_v3.32 directory (on Windows 7/8, right-click and choose "Run as administrator")
Entering Loader Mode
There are two ways to enter Loader mode:
Enter Loader Mode via Terminal Command
Enter the command directly in a terminal:
- After the adb terminal is up, enter
reboot loader to enter Loader mode.
Enter Loader mode
Enter Loader Mode via the BOOT Switch
Switch to upgrade mode with the BOOT switch:
- Disconnect all power
- Set the BOOT switch (or button) on the carrier board to ON
- Power on; the module automatically enters
Loader mode - After the upgrade completes, set the BOOT switch back to OFF and power on again
Start Upgrading
Follow the steps below to upgrade the DL568.
Upgrade Steps
1-2Extract the firmware3Check and confirm the device is in Loader mode4Select the firmware extracted in steps1-25Click the Upgrade button
Start upgrading
Upgrade Complete
Wait for Download firmware 100% and Download firmware success, which indicate the upgrade is complete.
Upgrade complete
Extract the tools
Install the driver
Extract and run RKDevTool.exe in the RKDevTool_Release_v3.32 directory (on Windows 7/8, right-click and choose "Run as administrator")
Enter Loader mode
Start upgrading
Upgrade complete