Skip to main content

Upgrade Overview

Navigation bar

Preface​

This document describes how to flash firmware from a host PC onto the DL568 module. Choose the appropriate upgrade method according to your host operating system and firmware type.

DL568 is a smart module in an LGA package and requires a carrier board of your own design for upgrading and booting.

In general, unless the hardware is damaged, Rockchip-based devices cannot be bricked.

Tools Required​

  • DL568 module + custom carrier board
  • Host PC
  • A working USB data cable

Preparing Firmware​

Firmware can be built from the SDK, which has not been publicly released yet. There are generally two types of firmware files:

Unified firmware and partition firmware. With the unified firmware unpack/pack tool, a unified firmware can be unpacked into multiple partition images, and multiple partition images can be merged into a single unified firmware.

  • Unified firmware contains multiple partition images and is a single file packed from the partition table, bootloader, uboot, kernel, system and other files.

    Officially released firmware uses the unified firmware format. Upgrading with unified firmware updates all partitions and the partition table on the device, and erases all data on the device.

  • Partition firmware refers to individual files for each function, such as the partition table, bootloader and kernel, generated during development.

    Individual partition images can update only the specified partition while keeping other partitions intact, which is convenient for debugging during development.

Flashing Tools​

Driver​

  • To ensure all devices use the latest driver, select Uninstall Driver first, then select Install Driver.

Release_DriverAssistant.zip

Photo Install the driver

Flashing Tool​

RKDevTool_Release_v3.32

Photo Extract and run RKDevTool.exe in the RKDevTool_Release_v3.32 directory (on Windows 7/8, right-click and choose "Run as administrator")

Upgrade Methods​

Rockchip supports upgrading firmware in the following way:

Upgrade Firmware via eMMC​

  • Connect the USB0 connector routed out on the carrier board to the PC with a USB data cable, and flash the firmware to the module's eMMC using the upgrade tool.

Boot Modes​

Normal Mode​

Normal mode is the regular boot process, where each component is loaded in sequence and the system starts normally.

Loader Mode​

In Loader mode, the bootloader enters the upgrade state and waits for host commands, used for firmware upgrade and similar operations.

AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →