Skip to main content

Interface Description

Navigation bar

The module uses an LGA 453-pin package. The table below lists the interface resources available on the module; for detailed pin definitions, refer to the "DL568 Pin Assignment and Pin Description".

Interface Resources​

InterfaceQuantity / CapabilityNotes
RGMII1 groupExternal gigabit PHY for a single gigabit Ethernet port
USB1 × USB3.0 OTG + 1 × USB3.0 HOST + 2 × USB2.0 HOSTUSB0 supports firmware upgrade (USB2.0 lane)
DisplayHDMI 2.0 / 2 × MIPI DSI / eDP 1.3 / LVDS / RGBUp to three independent displays
Camera1 × 4-lane MIPI CSI (splittable into 2 × 2-lane) / DVPUp to 8 MP
PCIe1 × PCIe 2.0 1-lane + 1 × PCIe 3.0 2-lanePCIe 2.0 RC only; PCIe 3.0 supports RC/EP
SATAUp to 3 × SATA 3.0Multiplexed with USB3.0 / PCIe
SD card1 × SD 3.0Hot-plug supported
UART8 groupsUp to 4 Mbps
I2C / SPII2C 5 groups; SPI 4 groupsI2C master mode only
CANUp to 3 groupsCAN FD
ADC5 channels, 10-bitGeneral-purpose ADC
AudioAnalog microphone, headphone, speaker, PDMPDM up to 6 channels
GPIOUp to 107 pinsSee pin description for multiplexed functions
WirelessWi-Fi 6 + Bluetooth 5.2AIC8800, external 2.4G/5G antenna

Carrier Board Design Notes​

DL568 is an LGA SMT module and cannot be used standalone; a carrier board must be designed and SMT assembled. Pay attention to the following when designing the carrier board:

  • Ethernet: the module provides only 1 RGMII group; an external gigabit PHY (e.g. RTL8211F-CG) is required for a single gigabit Ethernet port.
  • USB: USB0 is the firmware upgrade channel and supports upgrade over the USB 2.0 lane only. The carrier board should route USB0 to a pluggable connector and reserve a BOOT button or DIP switch.
  • Debug UART: the debug port is UART2, default baud rate 1500000.
  • Wireless: Wi-Fi / Bluetooth antennas require 50 Ω impedance control; refer to the "Fanconn Antenna Design Guide" for antenna design.
  • Power: the module supply range is 3.3 ~ 3.5 V; for ripple and stability requirements, refer to the "DL568 Hardware Design Manual".
AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →