Skip to main content

Firmware Upgrade

Navigation bar

Preface​

This document describes how to flash firmware from a host PC into the storage of the DL562 module via a data cable.

Choose the firmware and the appropriate upgrade method according to your actual needs.

Obtaining Firmware​

Build from the SDK​

The DL562 SDK has not been publicly released yet.

Installing the Flashing Tool​

Download Resources​

Install the RK USB driver: Release_DriverAssistant.zip

Run the RK flashing tool: RKDevTool_Release_v3.32

Extract​

  • Extract Release_DriverAssistant and RKDevTool_Release_v3.32

Photo Extract the tools

Install the Driver​

  • To ensure all devices use the latest driver, select Uninstall Driver first, then select Install Driver.

Photo Install the driver

Run the Flashing Tool​

Photo Extract and run RKDevTool.exe in the RKDevTool_Release_v3.32 directory (on Windows 7/8, right-click and choose "Run as administrator")

Entering Loader Mode​

There are two ways to enter Loader mode:

Enter Loader Mode via Terminal Command​

Enter the command directly in a terminal:

  • After the adb terminal is up, enter reboot loader to enter Loader mode.

Photo Enter Loader mode

Enter Loader Mode via the BOOT Switch​

Switch to upgrade mode with the BOOT (VOL_UP/BOOT) switch:

  1. Disconnect all power
  2. Hold the BOOT button on the carrier board (pull VOL_UP/BOOT low)
  3. Connect the USB cable and power on; the module automatically enters Loader mode
  4. Release the button once the PC detects the USB device
Note: reserve a BOOT button when designing the carrier board; the signal is VOL_UP/BOOT (active low)

Enter Maskrom Mode via EDL​

If Loader mode cannot be entered, pull the EDL pin low and power on again to force Maskrom mode for recovery.

Start Upgrading​

Follow the steps below to upgrade the DL562.

Upgrade Steps​

  • 1-2 Extract the firmware
  • 3 Check and confirm the device is in Loader mode
  • 4 Select the firmware extracted in steps 1-2
  • 5 Click the Upgrade button

Photo Start upgrading

Upgrade Complete​

Wait for Download firmware 100% and Download firmware success, which indicate the upgrade is complete.

Photo Upgrade complete

AI Translation Notice

This page was translated into English by AI and is provided for reference only. The original document is written in Chinese. If there is any discrepancy, the Chinese version prevails.

本页英文内容由 AI 自动翻译生成,仅供参考;原文为中文,如有差异请以中文原文为准。

查看中文原文 / View the Chinese original →