FAQ

Frequently Asked Questions
Can the DL562 be used standalone?
No. DL562 is a smart module in an LCC + LGA 447-pin SMT package; it requires a carrier board of your own design and SMT assembly before use.
How many Ethernet ports are supported?
The module exposes 1 RGMII group and up to 2 RMII groups, and PHYs must be added on the carrier board. This allows combinations such as one gigabit port, or gigabit + 100M, or dual 100M, depending on the carrier board design.
Is Wi-Fi / Bluetooth built in?
No. DL562 has no onboard wireless. Wi-Fi is connected via SDIO and Bluetooth via UART; the module exposes control signals such as WIFI_REG_ON, WIFI_WAKE_HOST, BT_REG_ON and BT_WAKE_HOST.
Where can I download the firmware and SDK?
The DL562 firmware and SDK have not been publicly released yet. Contact Fanconn technical support.
Which operating systems does the module support?
- Linux (kernel 5.10)
- Android 13
Please follow future documentation updates for release status.
What should I check if the USB device is not detected during upgrade?
Check the following in order:
- Whether VBAT is around 3.4 V and the supply can deliver enough current (peak about 3 A)
- Whether the USB cable is connected to the USB0 (OTG) connector on the carrier board
- Whether the BOOT (VOL_UP/BOOT) button is held while powering on to enter Loader mode
- Whether the RK USB driver is properly installed on the PC
If Loader mode still cannot be entered, pull the EDL pin low and power on to enter Maskrom mode for recovery.
Can memory and storage be customized?
Yes. The commercial-grade default is LPDDR4x 2 GB + eMMC 32 GB, with 1 GB + 8 GB, 4 GB + 32 GB and 4 GB + 64 GB optional; the industrial-grade default is 2 GB + 16 GB, with 1 GB + 8 GB and 4 GB + 32 GB optional.
What can the NPU be used for?
DL562 integrates a 1 TOPS NPU with RKNN toolchain support, suitable for common vision models such as object detection, face recognition and classification. Models must be converted and quantized on a PC before deployment.